|
各位大神,最近看到一款非标器具输入插座可以和标准连接器结合,请问这样是符合标准吗?
* i9 e/ {4 M- c& k7 L! b3 ~" e下面是标准的内容:
4 |( {" O$ }3 b; HIEC60320-1 AMD 2007 9.6 的. |6 X( P% y9 |& Y
NOTE 3 It must not be possible to engage such a non-standard accessory with a complementary accessory
1 K) q7 N1 O; A% d7 y0 gcomplying with the standard sheets, but of a different current rating. Neither shall it be possible to engage it with a
& {# h4 p' l: m! Q5 a; ~; o \5 ostandardized complementary accessory of the same rating if, by so doing, live parts are rendered any more# w4 W6 L2 I4 c# w3 O
accessible than is the case with a standardized appliance coupler of the same rating or if the combination of nonstandardized accessory and standard complementary accessory fails to comply with the requirements of this
" K& L- q3 V, ?6 ]9 wstandard other than the dimensions in the standard sheets.
8 t6 y: R! w7 n, O! E! {. I1 ]8 J: k, t. k' r% m7 h2 u
这句话说了非标除了尺寸上不符合标准但其它方面满足标准要求的话是可以的.9 W# p5 X& f0 c! _: A- p7 d* n
但标准里边还有这么一句话让我不知道怎么判断:
) |( }& O" @) A4 W$ g
, c; l1 a2 q+ E4 |Small deviations from the dimension as specified in the standard sheets, which give the impression of a standardized coupler and lead to confusion with standardized appliance coupler, are not allowed.
" ^: U C' Y n9 q/ w这句话表面了如果跟标准有差别的非标可以插进标准器件,造成使用者的混淆,是不允许的., F. K/ J# n0 W( X9 f M. p' P" O
/ v0 X$ |9 d+ l
有木有大神出来解答下?
& t7 q5 r u7 T' h' t1 v; `- g3 |6 v0 Y' t
6 D( [$ L3 d* x8 T( I5 ~ n& [
|
|