|
5.19 Measurements of cell voltages or battery voltages shall be made using a single pole resistive-capacitive low pass filter with a –3 dB roll off frequency of 5 kH±0,5 kHz. To determine if the upper limit charging voltage has been exceeded, the peak value of the filtered voltage shall be measured with a tolerance of ±1 %.
7 _* t# G% m/ l% I1 @3 f v; m' O5 f8 \
When measuring cell voltages or battery voltages, the peak value of any superimposed ripple exceeding 10 % of the average value shall be included. Transient voltages are ignored, such as a temporary increase of voltage, for example, after the battery is removed from the charging
5 k/ @8 r& I N6 @* n/ L2 g6 jsystem.
' B J; Z! R4 ?$ t# C( I1 Y1 D/ Z
% X. z" W8 k e% o6 e这两段话所说的是哪种设备? v8 _* M+ D% ?
- d2 c$ w; m* t2 B; B
& @" x* N- l8 i6 q. y |
|