安规网

标题: 电池过充测试 [打印本页]

作者: 贺小梅    时间: 2011-11-15 17:39
标题: 电池过充测试
请教一下,4.3.8的电池异常过充测试,保护板应该短路哪里?由于是要电池饱和状态做这个测试,那么它的充电电流不可能比 正常充电电流大吧?
作者: 茶馆    时间: 2011-11-15 17:43
短路电路中影响充电电流大小的元器件 一般是使充电电流高于 或者远大于正常充电电流
作者: davidfu    时间: 2011-11-15 17:43
看具体电路,吧那个限压的电路给failed掉
作者: 贺小梅    时间: 2011-11-15 17:45
引用第1楼茶馆于2011-11-15 17:43发表的  :
+ a( k' }* I5 }, Y短路电路中影响充电电流大小的元器件 一般是使充电电流高于 或者远大于正常充电电流
' S2 u" B; W6 N5 o( Y1 \! X
但是,这个测试是电池充满电的情况下做的,就算短路了保护板,它的充电电流会高于正常充电电流?
作者: 贺小梅    时间: 2011-11-15 17:52
我已附上保护板电路图,请问,应该短路哪里呢?
作者: 贺小梅    时间: 2011-11-15 17:56
我晕,QQ空间的图不能用,百度空间的图不能用,如何才能上传图片?
作者: davidfu    时间: 2011-11-15 18:02
电池饱和状态下,放电短路U2两脚,短路P-到电池负极,使电池过放。看会不会漏液,爆炸,起火等。
作者: davidfu    时间: 2011-11-15 18:03
充满电的话,那么电流就会很小到没有。充不进去电了
作者: 贺小梅    时间: 2011-11-15 23:49
引用第6楼davidfu于2011-11-15 18:02发表的  :; z1 j8 I: a2 ^2 z. q
电池饱和状态下,放电短路U2两脚,短路P-到电池负极,使电池过放。看会不会漏液,爆炸,起火等。
谢谢这位仁兄的解答,你说的是放电?那么过充也一样短路那里吗?在电池饱满的状态下,短路保护板充电,还有电流的,相当于直接对电芯充电。
作者: 山炮    时间: 2011-11-16 00:17
锂电池标准中本来就有电芯的过充电、短路等试验。不过,手机电池国家标准中对电芯的要求工厂都达不到,有试验基本上都爆炸了。
作者: 琥珀流云    时间: 2011-11-16 09:46
你做电池异常过充,应该是空电池吧
- `' K5 W& v8 ~4 f( M  M, K) S2 VOvercharging of a rechargeable battery. The battery is charged under each of the; m& P6 q3 g1 d& u
following conditions in turn.
6 ?% s$ N1 i6 H, ~# B: W- U• The battery charging circuit is adjusted with the battery disconnected to give 106 % of$ v/ l! W$ x* K
the rated output voltage of the charger, or the maximum charging voltage available' O" y, b3 l  R6 O( \' Y
from the charger (without simulation of faults), whichever is the higher attainable
! u4 ~: I8 [1 l& xvalue. The battery is then charged for 7 h.
1 v% u& k; q: s* S. c8 R! B• The battery charging circuit is adjusted, with the battery disconnected, to 100 % of the0 h5 I) k; Q# C. i- Q
rated output voltage of the charger. The battery is charged while briefly subjected to& A8 A8 H8 U, j3 V
the simulation of any single component failure that is likely to occur in the charging% i8 N4 W7 Z! a( S
circuit and that results in overcharging of the battery. To minimize testing time, the& w7 O7 I" U; m' r: E3 e
failure is chosen that causes the highest overcharging current. The battery is then
* R4 G" r! Z' E5 w4 r0 c, hcharged for a single period of 7 h with that simulated failure in place.
作者: xingle    时间: 2011-11-16 10:10
U1 Pin5-6, U2 输入到电池,R1短路就好了。。。
作者: 贺小梅    时间: 2011-11-28 17:38
引用第10楼琥珀流云于2011-11-16 09:46发表的  :& [- Z( b. u9 S, z' x* p& j
你做电池异常过充,应该是空电池吧( x/ [+ o: x0 ?
Overcharging of a rechargeable battery. The battery is charged under each of the1 Y8 d* ^, E* f! A
following conditions in turn.: M" n* ^, q. S: S; _; X
• The battery charging circuit is adjusted with the battery disconnected to give 106 % of
1 a- q/ n. m7 g9 f' Sthe rated output voltage of the charger, or the maximum charging voltage available
, Q0 m/ `) V7 b. ]; g% [4 x: M.......
这个测试对于可充电电池来说,是要在饱和状态下做的。




欢迎光临 安规网 (http://bbs.angui.org/) Powered by Discuz! X3.2