安规网

标题: 请教UL 1029 放电灯镇流器距离要求 [打印本页]

作者: guxia    时间: 2011-2-18 11:00
标题: 请教UL 1029 放电灯镇流器距离要求
这里有一个放电灯镇流器,金属外壳是接地的.测量PCB边缘的焊点点到金属外壳的电压有400V左右.
5 f& p6 k( ?3 H9 s那么这个点到金属外壳的距离是不是要求有9.5mm呢./ V6 u- `1 v1 B- |7 e5 X
UL 对于接地的外壳也要有这么大的要求么?; b. r) y; L1 t' ~

" O4 ^$ S/ B' `7 Q# d; `请教高人.
作者: Liu    时间: 2011-2-18 11:43
根据UL 1029的:$ i% B6 C. z" H
15.1 Spacings through air (clearance) and over surface of insulating material (creepage distance) between:
/ s! m2 }! @% p3 K2 ?9 Za) Uninsulated live parts of opposite polarity, and0 }9 w) n0 C4 V& _+ \
b) An uninsulated live part and a dead metal part that may be grounded, a metal part exposed to contact by persons, or a metal surface on which the ballast is mounted as intended, shall be not less than indicated in Table 15.1.
/ U5 U6 K2 M$ S+ b: z8 ~7 u: y+ x+ [
1 i0 I9 b- z/ f' |0 B1 m5 v确实是这个要求,没错。
作者: guxia    时间: 2011-10-10 22:11
谢谢。了解了。




欢迎光临 安规网 (http://bbs.angui.org/) Powered by Discuz! X3.2