安规网

标题: 关于电源线的测试 [打印本页]

作者: 想飞的鱼 时间: 2010-8-7 14:13
标题: 关于电源线的测试
现一手持式器具报备规格为0.5平方毫米的电源线,没通过测试.
方得知:
"对于手持式搅拌器, 电源线的绕折测试需增加以下的项目：
施加10N的力, 不考虑电源线的尺寸，角度: 180 度(垂直方向的两边各90度);
2000 周期, 每分钟6 次"
这是什么时候出的新规定?

作者: luqing_sz 时间: 2010-8-7 14:16
与电源线长度及横截面积没关系,见.2008版的标准.

作者: luqing_sz 时间: 2010-8-7 14:28
一直以来有这个测试,见60335-2-14//25.14
25.14 Addition: Hand-held blenders and hand-held mixers are also subjected to the following test while mounted on an apparatus similar to that of Figure 8. The supply cord is suspended vertically from the appliance and loaded so that a force of 10 N is applied. The oscillating part is moved through an angle of 180° and back to the initial position. The number of flexings is 2 000, the rate of flexing being six per minute. NOTE 101 The appliance is mounted so that the direction of flexing corresponds to that most likely to occur when the supply cord is wound around it for storage.

作者: mahatma.yao 时间: 2010-8-7 17:53
手持式器具是加了这一条测试

作者: shuyingaaa 时间: 2010-8-7 20:33
这个测试一般都能过的吧，除非电源线的质量是太差了些

作者: SMHF 时间: 2010-8-24 17:06
GB4706.15-2003版已经有规定了，现在是2008版了。

作者: asset509 时间: 2010-8-27 13:24

引用第2楼luqing_sz于2010-08-07 14:28发表的 :$ y* ~8 ?! T/ ~9 g+ S7 r5 F6 p: U
一直以来有这个测试,见60335-2-14//25.14
6 n S! x/ [* n# n25.14 Addition: Hand-held blenders and hand-held mixers are also subjected to the following test while mounted on an apparatus similar to that of Figure 8. The supply cord is suspended vertically from the appliance and loaded so that a force of 10 N is applied. The oscillating part is moved through an angle of 180° and back to the initial position. The number of flexings is 2 000, the rate of flexing being six per minute. NOTE 101 The appliance is mounted so that the direction of flexing corresponds to that most likely to occur when the supply cord is wound around it for storage.

我們做風筒風梳的都要做這個實驗的了

欢迎光临安规网 (http://bbs.angui.org/)