标题: Humidity conditioning [打印本页] 作者: a324015116 时间: 2010-8-2 15:48 标题: Humidity conditioning A device intended for use in damp or wet locations (see Clauses 7.2 and 7.3) and having accessible non-current-carrying metal parts shall be exposed for 48 hours to moist air having a relative humidity of 93 ±2 % at a temperature of 25 ±2 °C. Following the 48-hour period and while still exposed to moist air, the device shall comply with the requirements for dielectric voltage-withstand between current-carrying parts and accessible non-current-carrying metal parts in accordance with Clause 8.6 and operate normally. Alternate chamber conditions may be 88 ±2 % at a temperature of 32 ±2 °C or 93 ±2% at a temperature of 28 ±2 °C. # V/ b: Y# P$ n) }0 k" g
* l4 }$ ]2 k) E" _ g
; `& K& n! J# C3 n
其中有 Following the 48-hour period and while still exposed to moist air, the device shall comply with the requirements for dielectric voltage-withstand between current-carrying parts and accessible non-current-carrying metal parts in accordance with Clause 8.6 and operate normally。 - o1 t* ^! A; k0 C这句话的意思是不是说48小时后要把样品继续放在潮湿环境中打高压？还是其它什么意思。谢谢！作者: barry-xu 时间: 2010-8-2 15:51
没有错，CB的标准测试要求！作者: a324015116 时间: 2010-8-2 16:09
要实现这样的环境，我这里就只能放在恒温恒湿箱里，然后通过箱体旁的孔来连线，如果那样做会不会有危险！潮湿环境中能够打高压么？作者: sugar__box 时间: 2010-8-2 16:21
没关系的.. 你就用两根线事先引出来好了..到48后直接在线的两端打就可以了..注意下选线..还有线之间的距离.确保测试的时候线不会影响..以前在潮湿箱里做过绝缘电阻的.作者: aojia 时间: 2010-8-2 16:21
不危险，务必要求设备别带进箱子里哦。潮态后的耐压，就必须在潮态环境下打作者: a324015116 时间: 2010-8-2 16:30
没关系的.. 你就用两根线事先引出来好了 9 U- q+ h, p# n" p1 f [, x% IPosted: 2010-08-02 16:21 | 3 楼 ( V5 C9 ], ]( W T q' d
$ @* [2 t" X7 ~% Y2 W% l
