引用第4楼gordon于2010-06-28 13:31发表的 :. G5 _5 f! c/ p! y7 \1 ]
如果我的供应商自己担保没问题呢。我们是整机的。如果整机出口到北美了。会不会人家查这些电源线配件的。
引用第11楼andychen于2010-06-28 14:41发表的 :+ s+ k: T. B: b6 d6 e
我也相信需要报备.
但我有个问题: 1. 如果电源插头供应商第一次就给你送已经更改了尺寸又没有报备的插头;! j+ Z1 ]% Y7 ?% V0 `1 Q, [* t4 M
2. 同时更新了规格书;/ m# f( v0 ~$ R( ^- S+ F+ r
3. 你在UL网站上查UL File No.也是有效的;4 l4 X; U+ k) z$ G- s
.......
引用第12楼Andy.Yang于2010-06-28 14:56发表的 :6 ^: r) X0 ^' j
0 T, P" H% M" y1 Q, ^; x
Your know there is detailed description about the attachment plug in the FUS procedure, and there is an agreement between UL and its clients that the products must fulfill the description of its FUS procedure, so if revision occurs, it must be reevaluated by UL, even if only paper work,no additional tests are needed. As for the UL file No. can be checked through UL's website, I can tell you that the UL website only shows some general information about the products, such as the model No. and the marking description, that does not mean you can change your products as your will if the Model No. is not changed., y, Q# |# h/ d6 s6 Q! D) ^
1 c5 M5 i3 ^$ X* V, T
Make a conclusion that, as a certification engineer, you must focus on every change or redesign about your products and then compare these revisions with your FUS procedure and the related standards , check if the revision can fulfill the description about its FUS procedure or can fulfill the standards' requirements.
引用第11楼andychen于2010-06-28 14:41发表的 :% z" c. Z& [' x7 L4 v9 K/ |
我也相信需要报备.( N' X P# g! g, R
6 r; T" [2 c, a) \! N/ T- f+ b
但我有个问题: 1. 如果电源插头供应商第一次就给你送已经更改了尺寸又没有报备的插头;+ k7 n+ ^) i* g: D
2. 同时更新了规格书;3 }. _1 ~' A& j
3. 你在UL网站上查UL File No.也是有效的;
.......
引用第13楼andychen于2010-06-28 15:10发表的 :& N% P4 J. f1 G B; b, F( Y
是不是说,你用每一家有UL认证的产品,都需要向其供应商要其产品的FUS,不然不能用?
欢迎光临 安规网 (http://bbs.angui.org/) | Powered by Discuz! X3.2 |