安规网

标题: 在GS/CE中的电压残留测试的要求是怎样的? [打印本页]

作者: zgh1995    时间: 2009-8-24 10:33
标题: 在GS/CE中的电压残留测试的要求是怎样的?
在GS/CE中的电压残留测试的要求是怎样的?
作者: sclongwar    时间: 2009-8-24 10:44
标准一样,判定结果也是不一样。请列出你产品所使用的标准。
作者: zgh1995    时间: 2009-8-24 12:59
是电暖器,用的应为IEC60335-1/60335-2-30.。我只记得拨电后1秒钟内,插头两端的电压应降到安全电压内。只是不记行这个安全电压定为几伏了,一般来说是45V,但又好像是36V,总之记不清了。
作者: wolfxu    时间: 2009-8-24 13:13
引用第2楼zgh1995于2009-08-24 12:59发表的  :) {' `4 i* s$ [1 i$ L3 y
是电暖器,用的应为IEC60335-1/60335-2-30.。我只记得拨电后1秒钟内,插头两端的电压应降到安全电压内。只是不记行这个安全电压定为几伏了,一般来说是45V,但又好像是36V,总之记不清了。
这个你就要查法规了啊,是不是42.4V啊?你在到法规中确认一下吧?
作者: zgh1995    时间: 2009-8-24 15:17
谢谢,好像是。我只记得日本是45V,我刚到新公司,标准没带。这边又没有。
作者: milighost    时间: 2009-8-24 15:38
60335-1的22.5条+ t6 b+ {* U& S, a+ N4 v7 p  u( L) A
34V
' ?5 ]/ w: `$ T1 a5 j3 k3 l, M9 }7 y: M5 o
22.5 Appliances intended to be connected to the supply mains by means of a plug shall be
8 \2 z0 V0 z: d' s* J) }7 s! kconstructed so that in normal use there is no risk of electric shock from charged capacitors
/ g7 D8 J: W& A( f+ w( ewhen the pins of the plug are touched." H6 t0 X9 V( {1 i7 @
NOTE Capacitors having a rated capacitance up to 0,1 μF are not considered to entail a risk of electric shock.& m( m5 _: B' K6 v' H8 u+ N
Compliance is checked by the following test.
( P. h% i$ D# o+ NThe appliance is supplied at rated voltage. Any switch is then placed in the off position and" S9 K3 ^% S, f% G0 d1 p6 o
the appliance is disconnected from the supply mains at the instant of voltage peak. One4 J' r) V' m5 K4 _% p
second after disconnection, the voltage between the pins of the plug is measured with an
+ U7 s' J6 a* q& [+ ^; Kinstrument that does not appreciably affect the value to be measured.
# w5 v' I0 p& Y$ b7 K2 JThe voltage shall not exceed 34 V.
作者: zgh1995    时间: 2009-8-24 21:50
太谢谢milighost 了。




欢迎光临 安规网 (http://bbs.angui.org/) Powered by Discuz! X3.2