安规网

标题: 关于EN71-1利边 和 利尖 [打印本页]

作者: winnie.zt    时间: 2009-6-23 15:07
标题: 关于EN71-1利边 和 利尖
各位大侠:
* d( v" `* c# r/ y' a3 l1 ^# I( W+ o- D( W% `
请问EN 71-1 中利尖、利边判断、突出物并没有像ASTM F963中指明滥用测试前后都要判断,是不是
7 b, n. D) L, A, ?+ z3 v
1 L+ j$ u4 p% o, t就意味着只要在滥用测试前判断就行了?还是标准中所说的可触及边、可触及尖点、突出物包括滥用+ C" |0 T" B/ ?4 Z1 s( ?
0 Q& v; b4 l% L7 g
测试前后的?
: L; t5 Y& A2 w8 B0 H4 d5 T/ |+ X8 ?+ e& u
谢谢!
作者: 书山有路勤为径    时间: 2009-6-23 16:13
滥用测试前后都要符合,即测试前后都要判断
作者: brian3439    时间: 2009-6-23 16:47
3岁以下的滥用前后都看,3岁以上的只看接受状态
作者: hewei    时间: 2009-6-23 17:59
引用第2楼brian3439于2009-06-23 16:47发表的  :% _* \& V2 u+ v7 Q
3岁以下的滥用前后都看,3岁以上的只看接受状态
欧洲看3+ 美国看4+
作者: 钱大权    时间: 2009-6-23 23:19
我认为是滥用后也要符合
作者: lai88    时间: 2009-6-24 08:35
我也是认为滥用后都适用。
作者: tanger    时间: 2009-6-24 08:43
对于EN71-1,一些三岁以上的玩具有些也需要做跌落测试,为了一些警告标示做跌落,譬如说一个适合三岁以上儿童玩耍的木制玩具,在接收到时候不存在小部件,为了发现潜在危险, 会做一些相关的滥用测试,直到找到小部件为止,如果扭力和拉力测试做完还没有出现小部件,跌落就自然而然也要做了,包括小球警告语句也是类似的。
* A$ u+ X( m2 U- d$ B# \& F& _7 z. ^4 H
对于ASTM F963,8岁以上(不包括八岁)的玩具不需要做滥用测试,所以八岁的玩具需要做滥用测试,八岁以上就不要做跌落测试了。尖点和利边测试则只针对八岁以下的玩具(不包括八岁)。
作者: qiqiqaqa    时间: 2009-6-24 11:50
4.8 Points and wires (see C.8)2 I5 y( c! G, S" f7 X# c2 [
Wires and accessible points shall not present an unreasonable risk of injury.
- Q" M, T, f4 B6 `a) Points on toys are considered as potentially hazardous sharp points if they are sharp as determined
. O( u2 ~- H0 b8 Faccording to 8.12 (sharpness of points). If the points fail the test, they shall then be assessed to determine
: |' |/ O: z+ {. I0 swhether they present an unreasonable risk of injury taking into account the foreseeable use of the toy5 B4 j: T/ ~  }% A
(see also 5.1)., e3 T- \- y& a0 A( T( G( R! f
Points of pencils and similar writing and drawing implements are not considered as sharp points.
( U. c% P. N4 H7 zb) Where it is essential for the functioning of the toy, sharp points may be used in toys intended for
! q6 @/ e. Y, R3 ]5 L( _( }8 F3 ~- {children over 36 months.
! `% m6 Z  N7 z* \The potential danger presented by sharp points shall be drawn to the attention of the user (see 7.7).
& h  k! f1 Z: M: @- }3 yPoints of pieces intended to serve as electrical conductors are considered to be functional points and do
5 v3 j6 H* D9 X/ H# h5 t6 t1 vnot require a warning.
4 H1 |8 J" `# x8 Xc) Toys which contain wires, likely to be bent, and wires used for stiffening or retention of form (e.g. in8 X  P0 p% W( U% C$ d5 P8 J/ j8 L
soft filled toys) shall not break and produce sharp points or protrude through the surface covering of the+ A& s) T4 h9 v" J7 V2 e, r
toy when tested according to 8.13 (flexibility of wires).
! |# Z& q) E% {从这里面看,是要在滥用测试后检查利尖的
作者: Jason-PAN    时间: 2009-6-24 12:40
EN71-1与ASTM F963两个标准的结构不同
+ C. I1 j2 W  B5 v9 x9 `
  G0 l: q3 E7 P9 U) HEN71-1是按年龄划分为两大项:
; O/ @  `1 _; W3 \/ t! [4.X项是一般要求,5.X项是针对三岁以下的特定要求。三岁以下则需要做一般的滥用。" L- @( t+ C! ^- {& U
其中,4.7(边)、4.8(尖端及铁线)只需按滥用前判断(铁线需弯曲滥用后),而5.1项(涉及利边、利尖等)则需要滥用后也判断。
" y4 L! S5 D$ c8 b5 L因此,若按3+进行测试,则利尖、利边只需按滥用前判断。
* p: D" i3 T: B9 }& f$ U+ h: M
! j7 w: d7 {1 c而ASTM F963则是按特征分项:4.7(边)、4.9(尖端),每一项里面包含了不同年龄段。
  n5 s5 R. {3 m4 e& U5 m4+:允许功能性利尖、利边0 q  F& |5 a9 P3 c1 C" V0 p8 ]
8+:不需要一般滥用
4 Z. J3 y; Y- Z1 E# J因此,若8+,只需滥用前判断即可% y7 q8 i% x- X

5 p+ d1 S: o7 ]( r3 J4 X+ b至于突出物,无论EN71-1还是ASTM F963都需要滥用,区别只是滥用要求不同。& N$ L' O; Q' ~4 u( f$ v+ w, H
EN71-1对有保护盖的突出物进行60N拉力测试
4 q: n7 \; ~' c( r1 N而ASTM F963则是所有的一般滥用
作者: peter1715    时间: 2009-6-24 13:02
可触及边、可触及尖点、突出物包括滥用% ~# N& M1 R+ f- o. s

; l$ ^  V* a/ z1 j9 p6 r测试前后
作者: DOCTORO    时间: 2009-6-26 23:41
我也是认为滥用后都适用。
作者: 飞虫    时间: 2009-6-29 19:12
滥用测试前后都要符合
作者: xilin    时间: 2009-6-30 17:41
意见不一致 我都不知道哪个说的正确了
作者: jason_steel    时间: 2009-6-30 18:24
意见不统一,你就再好好研究一下标准吧。标准的东西就是仁者见仁,智者见智,大家的意见也只是供你参考而已。
/ N0 ^: c: R, V! s6 Q4 X% a" x在EN里面,3-都要做abuse,3+只有部份才需要做abuse(protective component, driving mechanisms, masks and helmets, projectile's protective components, etc.)
! @1 g9 _% T+ P; W, C" y( _/ U所以很多3+产品只需要看as-received 状态的危险。
作者: eastnan    时间: 2009-7-1 11:34
引用第8楼Jason-PAN于2009-06-24 12:40发表的  :
2 q1 C) Y/ {" u' `$ b7 G7 u- l: FEN71-1与ASTM F963两个标准的结构不同0 Z' @* ~7 ^2 e+ H. Y  \
: u7 E1 E0 }0 z
EN71-1是按年龄划分为两大项:5 f& c$ h: \, L7 K+ I) l# q
4.X项是一般要求,5.X项是针对三岁以下的特定要求。三岁以下则需要做一般的滥用。
% I; T, Q& @- X. K& T6 T其中,4.7(边)、4.8(尖端及铁线)只需按滥用前判断(铁线需弯曲滥用后),而5.1项(涉及利边、利尖等)则需要滥用后也判断。9 J: b# e/ E3 ]$ M  n4 Y
.......
这个答案很详尽,正确。厉害




欢迎光临 安规网 (http://bbs.angui.org/) Powered by Discuz! X3.2