标题: IEC 60320-1 clause 9.5中的注1如何理解？ [打印本页] 作者: ljh809809 时间: 2015-10-23 17:34 标题: IEC 60320-1 clause 9.5中的注1如何理解？ 本帖最后由 ljh809809 于 2015-10-27 12:08 编辑 7 c9 T- |. _, S4 R
% L, G3 H3 @, O: x! E3 ~
9.5 If appliance inlets are arranged countersunk in the outer surface of equipment, and if this! a- \1 G# i5 ~' h6 W
surface is curved or inclined with respect to the axis of the appliance inlet, the arrangement3 V: @/ X m8 M% A
shall be such that, under any circumstances, the pin ends do not protrude beyond the limiting. C- d/ h) b9 A C- Z
surface of the shroud. 2 `% v4 Q4 e7 u/ h H; o* Q! YCompliance is checked by connecting all pins, including the earthing pin, if any, together with $ N6 y3 Y9 o9 ~/ ^" q9 wone pole of a contact indicator, the other pole being connected to a metal straight-edge ruler, 8 Z* c, v/ d1 |- N% @7 q rhaving a width wider than the largest inside dimension of the appliance inlet, which is placed in9 y2 [* y) a1 ?! U- [9 T
all possible directions over the opening of the shroud. The ruler shall not come into contact # f1 @6 U6 F# h$ o: s& a/ Hwith the pin ends.6 n6 d( T. P9 ~2 i) X, w$ k
NOTE 1 For 10 A and 16 A appliance inlets for class II equipment, the test shall be carried out with a simulated earthing pin. 8 e' m2 \2 l2 F4 a/ u3 m5 [, S9 g3 q! o/ [, O
问题：注1中， 如何用模拟接地插销来做检查？: T; O, t! t4 N% l) k; o. t