标题: 60335-1条款7.5 [打印本页] 作者: zephon 时间: 2013-11-28 11:37 标题: 60335-1条款7.5 if the difference between the limits of a rated voltage range does not exceed 10 % of the arithmetic mean value of the range, the marking for rated power input or rated current may be related to the arithmetic mean value of the range. 这个该怎么理解啊?可以举个例子吗- n* j L! Y7 a$ c p1 B! @# `6 b
2 F: y1 U; a/ Q' A2 B3 y$ u# Q 作者: jjlamshushushu 时间: 2013-11-28 11:58 本帖最后由 jjlamshushushu 于 2013-11-28 14:16 编辑 * h6 k6 W$ j |
4 f0 j8 [( p2 X
额定电压上下偏差范围的差值不超过其平均值的10%,则可以标识其平均值对应的输入功率或电流作者: zyhua1985 时间: 2013-11-29 20:39
1樓正解作者: lotte_528 时间: 2013-11-30 16:16
例:额定电压220-240V~ 额定功率:3000W 这个功率对应的电压是平均值230V作者: winson1982 时间: 2013-12-6 15:08
lotte_528 发表于 2013-11-30 16:16 5 a) u2 N0 w% v" I
例:额定电压220-240V~ 额定功率:3000W 这个功率对应的电压是平均值230V
$ E, o' V9 E/ n' k3 u. i6 ~
电压和功率的对应关系只是试验时的用的,铭牌上的标识是要和证书上完全一致的。1 o/ b5 R( H2 d5 Q$ K; X, u
证书上的电压、功率信息是根据检测样品铭牌上来的,只要确定了,就不能随便改了,应该在出报告之前就把这些参数确定下来,以后如要改动就要做证书、报告变更了。作者: choubaoer121 时间: 2013-12-8 23:16