4 Z6 P+ [1 E$ E
* U7 Y- _( s- Y0 p
Standard:8 q# C" L0 `# F
IEC 61010-1:1990 +A1:1992 + A2 8 J+ i( {7 |5 y:19950 B- ^4 W: k+ W- Z0 Q% c' I, f
Sub clause: . x' f% X: J+ c6 ]- L7 `# L6.10 Connection to - F! {1 Z, ]" T4 z! ~6 Imains supply source % r% L' _3 p: @1 ?# VSheet n. 334& [) ]7 n0 ^/ S8 _% T" T
Page 1(1) T4 o+ d Q8 y/ OSubject: 4 f- G. v4 X$ V( h& w8 ^Connection to mains supply source% p2 Q1 G- R. T
Key words: , v1 g" S' I) n9 Q5 w8 k( M* N- Mains supply source 9 R% L2 j' ~% v- y- Connections between parts 4 L j4 A# x+ p; u- B8 q w1 uDecision n. 23 taken at0 e9 H$ `+ ]" ^* w$ n8 P2 U
37th meeting/2000& x8 n% m: Q9 |
Question:! X. e$ M6 F" ~) R, R3 W% N) {
This clause specifies requirements for connections to the mains supply source and / N) J5 e5 [2 ~2 I" dconnections between parts of equipment. Clause 6.10.1 specifies requirements only for 2 K3 W1 V) E q& K" h0 n4 Cmains supply cords, where are the requirements for connections between partsof the & q$ C, J& c) h1 l9 D0 q2 \" V# x/ z5 ^equipment ?$ p" r! l" h9 N% j. b( W* \) R1 }9 R; i
Terminology for the connecting cords? Note, Figure 3 of 61010-1 shows terminology for ; n) b8 \$ Z% {# T& K/ ]4 {mains supply cord. , F- p2 ~6 U! b# o1 JDecision:" ^% l) H" O$ l& R: S) R
It has been agreed that where such connections are at mains potential than the requirement of - ?; I+ O/ Y. n9 T3 P$ J, vsub-clause 6.10 applies. % @# I% C- G- aExplanatory Notes: W2 l. j; ]% ]: Q! z/ Z: F% BThere are requirements for interconnecting cords for connecting parts of a system under+ Q+ j; q% b2 M9 n0 w
IEC61010-1. 4 w) S$ e! U' z3 Q, m8 iWhere interconnecting cables are at mains potent ial, it is important that such cords are at 6 |. [# \8 T" E% Uleast equivalent to the supply mains cord requirements. ! I2 D6 w' d _! B, \+ K r" T 6 K2 I" `; L- r( l[attach]76213[/attach]* R' f) J1 k* T4 K
6 j1 S H; M7 U5 p4 C